- A plus series is the extend upgrade version of A series
- Volt: 110~240v world wide use
- Light body width 60mm, thickness only 9mm
- True full spectrum aquarium lights, spectral coverage area 400-700nm, providing the necessary light and color for healthy growth.
- Provide sufficient brightness and realistic colors, so you see a clear and thorough real world
- Optimize the configuration to ensure the healthy growth of green and red water plants make fish more beautiful and moving
- LED cover made of aluminum alloy and finished with anodize surface treatment, effectively reduce the heat generation problem of high luminosity LED lamps and prevent from rust.
- Stainless Stand : 22x11cm.
- Material: Polymethyl Methacrylate
- Holder : 11mm, fit max 11mm thick tank.
- Power Input: AC100 - 240V, 50-60Hz
- Stand Sheets: W60 x D5 x H50mm
- Color temperature: Around 8,000K
- LED type: 5730
S2-Pro Controller Fetures:
- Material: Plastic
- Model: S2-pro
- Product connector: 5.5mm DC male with lock thread.
- Product size: width 6.5cm.
- Applicable to: compatible with conventional below 36V 100w with constant pressure LED lamps,like Chihiro light.
- Industrial-grade LED display digital tube that can be easily detected at any angle and light.
-100 - level dimming to meet the requirements of various plants and pets for light.At the same time, both open and close use the gradient mode to reduce the effect on fish.
-With 8 sets of time brightness Settings, timer switch, simulate the different brightness switch of nature. Combine the timer and the dimmer into one.
-0.05UM patch, mature sunrise and sunset procedures, all tested in the factory.
- Press the manual/automatic switch, long press into the timer setting.
- NO-1 and time cycle flicker, through + and - for the first set of time Settings.
- Press MODE key again, L000 flicker, through + and - for the first set of brightness Settings.
- Then press MODE key, NO-2 and time cycle flicker, through + and - to set the second set of time.
- Press MODE key again, L000 flicker, through + and - to set the second set of brightness Settings.
- In this way, 8 sets of data are set. Press MODE to exit after setting.
- P.S. If the time is set to "-- : --", the data on behalf of the group does not work.
- The S2-Pro should order seperately.
- 1 x Lighting Unit (Aluminum)
- 2 x Support Sheets ( Some screws are included)
- 1 x Power Code
- 1 x Wired Adjustable Switch
- 1 x Screwdriver